Set the EL to default settings

Return all unit parameters (via UDP packet)

The “X” command will return all parameters in the following form:

<M>xxxxxxxxxxxx<I>xxxxxxxx<D>xxxxxxxx<P>xxxx<T>xxxx<U>xxxxxxxxxxxx<C>xxxxxxxxxxxx<O>xxxxxxxxxxxx<S>xxxxxxxxxxxx

Remember that these are 2 character Hex pairs. Therefore, a twelve character stream is actually six, paired Hex numbers.

Make a connection with host computer. The “N” command can be used to automatically load sender’s IP and MAC address into the memory of the EL. This is a quick method of establishing a data connection to a single computer within a local network